2007 Ford Freestyle recalls and problems

On November 29, 2012, Ford Motor Company (Ford) initiated Customer Satisfaction Program 12N03 to extend warranty coverage terms for repair of engine idle RPM surge caused by throttle body deposits in all model year (MY) 2005 through 2007 Ford Freestyle, Five Hundred and Mercury Montego vehicles.The program extends the coverage for up to 10 years of service or 150,000 miles from the warranty start date of the vehicle (all vehicles are eligible for the program through May 31, 2013, regardless of mileage).Dealers will repair vehicles exhibiting the condition by removing and cleaning the throttle body and reprogramming the PCM with software containing an updated idle speed control strategy.According to Ford, some of the affected vehicles may experience momentary, intermittent engine idle RPM surge (idle flare) when stopped or during low speed driving maneuvers such as in a parking lot or driveway.Unstable idle speed control (dips and flares) around the target engine speed (700 rpm) can occur in vehicles with deposit build-up in the throttle body when the system adjusts engine speed in response to changes in engine load, typically from power steering application or air-conditioner compressor cycling.Idle speed control logic is only active at vehicle speeds below 3.5 mph and when the accelerator pedal is not applied.Ford testing of a vehicle with a worst case throttle body measured a maximum idle flare of 1360 RPM lasting approximately 1 second, which Ford indicated was consistent …

ON OCTOBER 14, 2008, ODI OPENED PE08-060 TO INVESTIGATE ALLEGATIONS OF CRACKED AND LEAKING SNAP-IN TIRE VALVES IN MODEL YEAR (MY) 2007 VEHICLES MANUFACTURED BY FORD MOTOR COMPANY.THE VALVES WERE SUPPLIED TO FORD BY TOPSEAL AUTO-PARTS, A SUBSIDIARY OF THE SHANGHAI BAOLONG AUTOMOTIVE CORPORATION IN CHINA.VALVES MADE BY TOPSEAL FOR AFTERMARKET SALE WERE THE SUBJECT OF TWO RECENT SAFETY RECALLS BY TECH INTERNATIONAL (08T-018) AND DILL AIR CONTROLS (08T-028), THE LATTER OF WHICH WAS INVESTIGATED BY ODI IN PE08-036 AND EA08-022.THE DEFECT CONDITIONS ADDRESSED BY THE AFTERMARKET TIRE VALVE RECALLS BOTH INVOLVED INADEQUATE RESISTANCE TO OZONE CRACKING DUE TO ISSUES WITH THE SUPPLY OF ANTI-OZONANT CHEMICALS TO TOPSEAL FOR A PERIOD FROM JULY TO MID-NOVEMBER 2006.THE AFTERMARKET VALVES WERE COMPOUNDED WITH A BLEND OF EPDM AND NATURAL RUBBER, USING A RELATIVELY LOW PERCENTAGE OF EPDM (EPDM PROVIDES INHERENT RESISTANCE TO OZONE CRACKING).HENCE, THE NEED FOR ANTI-OZONANT CHEMICALS AND THE PROBLEMS WITH CRACKING WHEN THOSE CHEMICALS WERE MISSING OR OUT OF SPECIFICATION IN SOME LOTS OF VALVES.BOTH RECALL CAMPAIGNS INVOLVED INSPECTION PROGRAMS TO IDENTIFY AND REPLACE VALVES WITH VISIBLE SURFACE CRACKING.ALTHOUGH THE TOPSEAL VALVES SUPPLIED TO FORD ALSO APPEAR TO HAVE BEEN AFFECTED BY THE ANTI-OZONANT SUPPLY ISSUES IN MID TO LATE-2006, FORD INDICATED THAT ITS VALVES WERE MADE AT A DIFFERENT TOPSEAL PRODUCTION LINE AND WERE COMPOUNDED WITH A HIGHER PERCENTAGE OF EPDM RUBBER TO MEET MORE STRINGE…