2006 Pontiac GTO recalls and problems

NOTE: THE COMPLAINT AND WARRANTY COUNTS GIVEN IN THE FAILURE REPORT SUMMARY OF THIS RESUME INCLUDE ALL RECORDS RELATED TO TIRE WEAR AND WHEEL ALIGNMENT AND ARE NOT LIMITED TO TIRE-STRUT CONTACT.GENERAL MOTORS (GM) IDENTIFIED TWO CONTRIBUTORS TO PREMATURE FRONT TIRE WEAR IN THE SUBJECT VEHICLES.ONE OF THE CONTRIBUTORS CAUSING THE PREMATURE TIRE WEAR WAS OUT OF SPECIFICATION NEGATIVE CAMBER.GM STATED THAT EXCESSIVE NEGATIVE CAMBER COULD BE CAUSED BY IMPROPER CAMBER SETTINGS FROM THE FACTORY OR BENDING OF THE FRONT STRUT ASSEMBLIES DUE TO SHARP ROAD IMPACT (I.E., SEVERE POT HOLES).TO IMPROVE CAMBER SETTINGS FROM THE FACTORY, GM STATED THAT FROM FEBRUARY OF 2005 THROUGH MAY OF 2006 SEVERAL MODIFICATIONS WERE MADE TO THE CAMBER SETTING FIXTURE.GM ALSO NOTED THAT EXCESSIVE NEGATIVE CAMBER COULD RESULT IN FRONT TIRE TO STRUT CONTACT, WHICH COULD ALSO BE CAUSED BY USE OF NON-ORIGINAL EQUIPMENT (OE) TIRES AND/OR WHEELS.GM STATED THAT CONTACT OF THE FRONT TIRE AND FRONT STRUT ASSEMBLY CAN CAUSE A POLISHING ON THE TIRE SIDEWALL AND/OR STRUT ASSEMBLY; HOWEVER, THIS DOES NOT CAUSE A SUDDEN LOSS OF AIR. GENERAL MOTORS PROVIDED ODI WITH THE FINAL FACTORY FRONT CAMBER SETTINGS WHERE AVAILABLE FOR COMPLAINT AND WARRANTY CLAIM VEHICLES.APPROXIMATELY 90 PERCENT OF THESE VEHICLES HAD RIGHT WHEEL CAMBER SETTINGS THAT WERE OUT OF DESIGN SPECIFICATION.FOUR PERCENT OF THE VEHICLES HAD LEFT WHEEL CAMBER SETTINGS THAT WERE OUT OF SPECIFICATION.IN A REVIEW OF CONSUMER COMPLAINTS, MOST NOTED EXCESSIVE T…