2017 Peterbilt 220 recalls and problems

The 2017 Peterbilt 220 has 1 recall and 0 owner complaints on file with NHTSA.

How the 2017 compares

Too few model years with complaints to compare.

1recalls
0complaints
0crashes
0fires
0injuries
—median miles

Owner complaints filed with NHTSA, not verified and not adjusted for sales. Ranking compares this model's own years only.

Does your car have an open recall?
Recalls apply to specific vehicles. Only a VIN lookup on NHTSA's official site shows whether yours is affected and still unrepaired.
Check your VIN →

1 recall

Power Train

Sep 6, 2017 · NHTSA campaign 17V554000 · 2,975 vehicles

Problem: PACCAR Incorporated (PACCAR) is recalling certain 2009-2010 Peterbilt 210 and 220 trucks; 2012-2018 Peterbilt 210 and 220 trucks; and 2010-2018 Kenworth K270 and K370 trucks. These LFNA trucks have a front axle sway bar link that may come loose on the frame rail end and fall into the path of the drag link, possibly binding the steering system.

Risk: If the sway bar link detaches and falls into the drag link, it may impact the ability of the vehicle to steer properly, increasing the risk of a crash.

Remedy & notes

PACCAR will notify owners, and dealers will inspect the upper sway bar link attachment for a hardened washer installed between the bushing and the nut, installing a washer if it is missing, free of charge. The recall began on October 2730, 2017. Owners may contact Kenworth customer service at 1-425-828-5000 or Peterbilt customer service at 1-940-591-4220. PACCAR's numbers for this recall are 817-D and 17KWE.

Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Recall text as published by NHTSA and the manufacturer.

NHTSA investigations

Quarter Fender Failures

PE20015 · opened Sep 21, 2020 · closed Oct 14, 2021
Summary

The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE21-015) based on one Vehicle Owner Questionnaire (VOQ) and supporting fleet reports. The reports indicated that the subject quarter fenders were prone to cracking and/or separation.After a comprehensive review of the data related to the quarter fender failures on the subject vehicles, ODI did not identify the existence of a safety-related defect trend. Quarter fender failures resulted in a warranty claim rate less than one percent (<1%) of the total vehicle population. All separations, including those due to tread separations, road hazards, etc., accounted for less than point one percent (<0.1%) of the total vehicle population.ODI discovered that the minimum recommended gap between the top of the quarter fender and the bottom of the trailer was not known or being followed. The optional quarter fenders were supplied by Fontaine Spray Systems (FSS), who recommended a two inch (2) gap. ODI analyzed the claim data using a calculated gap. A calculated gap using the top of the quarter fender flap and assuming the trailer is level with the top of the fifth wheel hitch was necessary, as PACCAR doesn't know specifically what trailer a purchaser will couple to the tractor. It is safe to assume no trailers on the market extend below the upper fifth wheel plate, but many do provide additional clearance over the wheels where the quarter fenders are located. ODI determined that 94 percent of warranty claims and…

2017 vs. other Peterbilt 220 years

Owner complaints by model year; the darker bar is the 2017. Click a bar to switch year.

Questions

Does the 2017 Peterbilt 220 have recalls?

Yes — NHTSA lists 1 recall campaign covering the 2017 Peterbilt 220, the latest from Sep 6, 2017 (power train). A recall applies to specific vehicles: enter your VIN at nhtsa.gov/recalls to see whether yours is affected and still open.

What are the most common problems with the 2017 Peterbilt 220?

Few complaints have been filed with NHTSA for the 2017 Peterbilt 220.