2001 Mercedes-Benz SLK recalls and problems

THE PETITIONER ALLEGES THAT COFFEE FROM A CUP, PLACED IN THE CUP HOLDER, SPILLED ONTO THE GEAR SHIFTER AND SHUT DOWN THE VEHICLE?S ENTIRE ELECTRICAL SYSTEM. THE CONCERN RAISED BY THE PETITIONER WAS INVESTIGATED (SQ01-010) AND WAS CLOSED AFTER ODI CONCLUDED THAT THE FACTS DID NOT DEMONSTRATE A SAFETY-RELATED DEFECT.ODI HAS SUBSEQUENTLY RECEIVED NINE MORE COMPLAINTS ALLEGING FLUID CONTAMINATION OF THE TRANSMISSION SHIFTER SINCE THE INVESTIGATION WAS CLOSED, NONE OF WHICH REPORT CRASHES OR INJURIES.THESE NINE COMPLAINANTS MAINLY EXPRESSED DISSATISFACTION WITH THE DESIGN OF THE CUP HOLDER AND THE COST OF REPLACING THE CONTAMINATED ELECTRONIC SELECTOR MODULE.SIMILARLY, IN PETITIONER?S CASE SHE WAS ABLE TO OPERATE THE VEHICLE TO A PLACE WHERE IT COULD BE SAFETY STOPPED AFTER THE LIQUID SPILLAGE.THE PETITIONER HAS NOT PROVIDED ANY EVIDENCE OF A SAFETY-RELATED DEFECT.IN VIEW OF THE FOREGOING AND THE NEED TO ALLOCATE AND PRIORITIZE NHTSA'S LIMITED RESOURCES TO BEST ACCOMPLISH THE AGENCY'S SAFETY MISSION, THE PETITION IS DENIED.

IN ITS LETTER DATED OCTOBER 28, 2005, MERCEDES-BENZ USA STATED THAT IT WOULD CONDUCT A SAFETY RECALL TO REMEDY DEFECTIVE BRAKE LAMP ASSEMBLIES IN MODEL YEAR 1998 THROUGH 2004 MERCEDES BENZ SLK VEHICLES.THE BASE OF THE BRAKE LAMP SOCKET CAN BE SUBJECT TO THERMAL DEFORMATION OVER TIME.THIS DEFORMATION CAN CAUSE MOVEMENT IN THE SOCKET-TO-BULB CONNECTION, WHICH MAY LEAD TO A LOOSENING OF THE ELECTRICAL CONTACTS IN THE SOCKET, AND FAILURE OF THE BULB TO ILLUMINATE.ALL REAR LAMP MODULES (WHICH CONTAIN BRAKE, TURN SIGNAL, TAIL AND BACKUP LAMPS) WILL BE REPLACED WITH REDESIGNED REAR LAMP MODULES WITH A MORE HEAT RESISTANT MATERIAL AND ENHANCED SOCKET HOLDER DESIGN TO WITHSTAND THE HEAT INSIDE THE REAR LAMP MODULE.SEE NHTSA RECALL NO. 05V505 FOR MORE INFORMATION.