2017 Ford Edge recalls and problems

The Office of Defects Investigation (ODI) received a petition on August 5, 2026, requesting a defect investigation into the 2.0 Liter EcoBoost engine on model year 2015-2018 Ford Edge vehicles. The petition alleges that engine coolant intrusion results in a significant loss of engine power, accompanied by an "Engine Coolant Over Temperature" warning message.  The petition further alleges that after the vehicle has sat and cooled down, the engine runs roughly and generates a check engine light for a cylinder misfire. This defect petition is being opened to evaluate the issue and determine whether to grant or deny the petition. The petition can be reviewed at NHTSA.gov under ODI number 11754989.

On October 3, 2024, NHTSA’s Office of Defects Investigation (ODI) opened this Preliminary Evaluation to investigate instances of rear brake hose ruptures causing a sudden and unexpected loss of braking in model year (MY) 2015-2017 Ford Edge vehicles manufactured by Ford Motor Company. The complaints allege that, without warning, the vehicle lost its ability to brake causing an unanticipated increase in the vehicle’s stopping distance. The complaints also allege that, prior to the rear brake hose rupture event, the vehicle had been serviced under recall 20V-469. Recall 20V469 involved MY 2015-2018 Ford Edge and MY 2016-2018 Lincoln MKX vehicles which may experience front brake hose ruptures causing increased brake pedal travel and a reduction in the rate of deceleration. Ford identified the cause of this safety defect as a consistent localized failure of the internal reinforcement braid of the brake hose due to cyclic fatigue via tensile/bending and torsional inputs during suspension and steering articulations. Ford also identified that only 88% of suspension articulation was utilized on the front brake hose test rig during life cycle testing. These findings, along with ODI’s identification of an emerging trend involving rear brake hose ruptures, prompted the opening of this investigation. ODI identified 64 Vehicle Owners Questionnaires related to this investigation, 2 involving a crash. These consumers were interviewed and reported experiencing sudden loss of braking ab…

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been n…