2005 Dodge RAM 1500 recalls and problems

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been n…

The Office of Defects Investigation (ODI) opened PE14-016 in June 2014 based on six inflator rupture incidents involving consumer owned vehicles produced by five vehicle manufacturers.All six vehicles were operated in Florida or Puerto Rico at the time of the rupture and for the majority of their service life, and were equipped with inflators produced by Takata, a tier-one supplier of automotive air bag systems.During the course of PE14-016, ODI determined that five additional vehicle manufacturers used inflators of a similar design and vintage also supplied by Takata. No evidence of field failures was found in vehicles produced by these five additional manufacturers.Nonetheless, at ODI's insistence, all 10 vehicle manufacturers initiated a regional recall within approximately two weeks of the opening of the investigation.The regions recalled initially included Florida, Puerto Rico, Hawaii, and the U.S. Virgin Islands, areas with high absolute humidity and climatic conditions believed to be a significant factor in the inflator ruptures.As part of the recall actions, inflators removed from remedied vehicles are to be returned to Takata for testing.Takata's initial test results on passenger inflators from remedied vehicles indicated a much higher than anticipated rupture frequency for inflators returned from Florida.Accordingly ODI requested all 10 manufacturers expand the regional recalls for passenger inflators to include other geographic areas where high absolute humidity co…

On December 16, 2014, Chrysler Group LLC submitted a Safety Recall Report to NHTSA describing a defect in the rear differential of approximately 256,956 model year (MY) 2005 Dodge Ram 1500 pickup trucks (NHTSA Recall No. 14V-796, Chrysler Recall No. P77).Chrysler's letter states that: 1) some of the recalled vehicles may have been built with an axle pinion nut that can loosen, due to an undersized spline on the pinion gear; and 2) a loose pinion may cause the rear axle to seize and/or the driveshaft to separate, resulting in the loss of vehicle control and/or a crash with little warning.The one crash and injury noted in Chrysler's Safety Recall Report is from a NHTSA complaint documented in Vehicle Owner Questionnaire (VOQ) 10508200.This complaint describes an incident in which the rear end of the truck locked up and skidded into a culvert, resulting in a head injury to the driver (concussion).ODI's failure counts in this resume do not include vehicles with evidence of previous repair or maintenance work that required removal of the pinion.Chrysler's recall remedy procedure will add a retention feature to the pinion nut on all affected vehicles.This investigation is closed based on Chrysler's recall.

The Office of Defects Investigation (ODI) opened PE14-016 in June 2014 based on six inflator rupture incidents involving consumer owned vehicles produced by five vehicle manufacturers.All six vehicles were operated in Florida or Puerto Rico at the time of the rupture and for the majority of their service life, and were equipped with inflators produced by Takata, a tier-one supplier of automotive air bag systems.During the course of PE14-016, ODI determined that five additional vehicle manufacturers used inflators of a similar design and vintage also supplied by Takata. No evidence of field failures was found in vehicles produced by these five additional manufacturers.Nonetheless, at ODI's insistence, all 10 vehicle manufacturers initiated a regional recall within approximately two weeks of the opening of the investigation.The regions recalled initially included Florida, Puerto Rico, Hawaii, and the U.S. Virgin Islands, areas with consistently high absolute humidity and climatic conditions believed to be a significant factor in the inflator ruptures.As part of the recall actions, inflators removed from remedied vehicles are to be returned to Takata for testing.Takata's initial test results on passenger inflators from remedied vehicles indicated a much higher than anticipated rupture frequency for inflators returned from Florida.Accordingly, ODI requested all 10 manufacturers expand the regional recalls for passenger inflators to include other geographic areas where high absolu…

ANALYSIS OF THE COMPLAINT, FIELD REPORT AND WARRANTY DATA SHOWS THAT THE MAJORITY OF STALLING INCIDENTS IN THE SUBJECT VEHICLES APPEAR TO BE RELATED TO THE ENGINE CALIBRATION CONCERNS THAT DAIMLERCHRYSLER ADDRESSED WITH SERVICE BULLETINS RELEASING REVISED PCM SOFTWARE.ANALYSIS OF THE COMPLAINTS AND ODI'S SURVEY OF OWNERS OF VEHICLES THAT RECEIVED ENGINE MANAGEMENT SOFTWARE UPDATES UNDER TSB #18-013-05 SHOW THAT THESE STALLING INCIDENTS HAVE THE FOLLOWING CHARACTERISTICS: - THEY OCCUR AT LOW SPEEDS, OFTEN DURING PARKING LOT ORDRIVEWAY MANEUVERS; - THEY OCCUR DURING DECELERATIONS, SUCH AS BRAKING FOR A STOP SIGN OR TRAFFIC SIGNAL; AND - THE OPERATOR IS ALMOST ALWAYS ABLE TO IMMEDIATELY RESTART THE VEHICLE.WHEN COMPARED WITH OTHER SAFETY DEFECT INVESTIGATIONS AND RECALLS OF CONDITIONS THAT RESULT IN STALLING DURING LOW-SPEED DECELERATION WITH IMMEDIATE ENGINE RESTART POSSIBLE, THE FAILURE RATE IN THE SUBJECT VEHICLES IS LOW.ANALYSES OF COMPLAINT AND WARRANTY DATA ALSO SHOW A DECLINING TREND.ACCORDINGLY, THIS INVESTIGATION IS CLOSED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT A SAFETY-RELATED DEFECT DOES NOT EXIST.THE AGENCY WILL CONTINUE TO MONITOR COMPLAINTS AND OTHER INFORMATION RELATING TO THE ALLEGED DEFECT IN THE SUBJECT VEHICLES AND TAKE FURTHER ACTION IN THE FUTURE IF WARRANTED.SEE DOCUMENT FILE FOR ADDITIONAL INFORMATION REGARDING THIS RESUME.