2013 BMW X5 Sav recalls and problems

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been n…

In a May 23, 2018 letter, BMW of North America, LLC (BMW) notified the National Highway Traffic Safety Administration (NHTSA) of a safety defect that may result in the loss of power steering assist in certain model year (MY) 2009 through 2013 BMW X5 xDrive35d vehicles (Recall 18V-336). The recall, which affects approximately 33,214 vehicles built from March 12, 2008 through June 27, 2013, corrects the remedy and expands the scope of a prior BMW recall (12V-550) which addressed idle pulley bolt failure in approximately 29,800 MY 2009 through 2012 BMW X5 xDrive35d vehicles built from September 1, 2008 through November 15, 2012. BMW's analysis indicates that due to a number of contributing factors it is possible that the bolt's pre-stressing force could drop to an extent that it results in the bolt becoming loosened over time. A loosening of the bolt could cause additional bending stress on top of the bolt. As a result, the bolt could break. If this were to happen, then a sudden loss of power steering assist could occur.If there were a loss of power steering assist, manual steering capability would be retained, although the effort required to steer the vehicle would be greater, and therefore may increase the risk of crash.ODI's analysis of the complaints it has received from the public (VOQ's) and BMW complaint data submitted in response to the information request letter for RQ18-001 identified a total of 93 unique VIN reports alleging failure of the idler pulley bolt after reca…