2010 Audi A3 recalls and problems

By letter dated October 3, 2011, Volkswagen Group of America, Inc. (VW) notified the National Highway Traffic Safety Administration (NHTSA) that it will conduct a safety recall to address a defect in approximately 168,275 model year (MY) 2009-2012 Volkswagen Jetta, Jetta Sportwagen, Golf, and Audi A3 vehicles equipped with the 2.0L TDI Common Rail Clean Diesel engine (NHTSA Recall No. 11V-490).The recalled Jetta and Jetta Sportwagen vehicles were built from May 2008 through September 2011, the Golf vehicles were built from May 2009 through September 2011, and the Audi A3 vehicles were built from September 2009 through September 2011.According to Volkswagen, in U.S. applications of the above cited TDI vehicles including engine codes CJAA and CBEA, the fuel injection pulses could coincide with the natural frequency of the injector line #2 in specific load and RPM conditions.This resonance creates additional stress on the fuel line which a small number of parts (based on the statistic spread of line strength) cannot withstand over its lifetime.As a contributing factor, VW indicated that a supplier used tube material with scratch marks from a grinding process during certain production periods.Lines manufactured in these periods were installed in vehicles produced in the following 10 months:December 2008, January-February 2009, October 2009, March-April 2010 and September-December 2010.Injector lines using this material exhibit a significantly higher failure rate.Dealers will repl…

The Office of Defects Investgation (ODI) opened EA11-003 on February 7, 2011, based on 160 complaints to ODI and Volkswagen involving high pressure fuel pump (HPFP) failures in model year (MY) 2009 through 2010 Volkswagen Jetta and Golf and Audi A3 TDI vehicles and questions regarding fuel sample results provided by Volkswagen as part of its response to PE10-034.During EA11-003, ODI analyzed design information, field experience and test data for MY 2009 through 2012 Volkswagen Jetta, Golf and Touareg and Audi A3 and Q7 vehicles equipped with TDI engines. Volkswagen has not identified any design or manufacturing defects in the subject TDI Clean Diesel pumps and has stated that the subject pumps were designed, tested and approved for use in the United States market, with substantial design margins for fuels that are out of specification.Volkswagen believes that misfueling with gasoline is the primary cause of HPFP drivetrain failures in the field.Only the Q7 vehicles were built with misfuel protection devices.In May 2013 Volkswagen initiated a service campaign to install misfuel protection devices in all MY 2009 through 2012 Jetta, Golf and A3 vehicles.Volkswagen implemented misfuel protection devices in all of the subject models beginning in MY 2013. ODI?s analysis of HPFP drivetrain failure incidents indicates that most failures do not result in engine stall while driving and, when pump drivetrain failure does result in stall while driving, it is usually preceded by numerous …

The Office of Defects Investigation (ODI) and Volkswagen (VW) have received a total of 160 complaints and field reports alleging incidents of engine stall and/or loss of power that appear to be related to high pressure fuel pump (HPFP) failures in certain model year (MY) 2009 through 2010 Volkswagen Jetta and MY 2010 Volkswagen Golf and Audi A3 vehicles equipped with TDI clean diesel engines.Approximately half of the reports indicate that the failure resulted in an engine stall incident, with many of these alleging stall incidents at highway speeds in traffic with no restart.There has been one minor crash alleged to have resulted from HPFP failure in the subject vehicles.In response to ODI's information request for PE10-034, VW indicated that it had found no defect related to motor vehicle safety with relation to the TDI Clean Diesel fuel system at issue in this investigation and attributed problems with HPFP failure to operation with gasoline contaminated diesel fuel.Volkswagen stated that even a small amount of gasoline in the diesel fuel may disrupt the necessary lubrication required and may cause the HPFP to fail.In response to concerns that fuel contamination was the major cause of HPFP and related fuel system failures, VW issued a Technical Service Bulletin in May 2010 (VW TB V011011 2023624 and Audi TB A011008 2023360-1), with instructions to inspect the diesel fuel for vehicles requiring fuel system service that have symptoms associated with HPFP failure.The bulletin …

THE SUBJECT VEHICLES ARE EQUIPPED WITH DIRECT SHIFT GEARBOX (DSG) TRANSMISSIONS, WHICH FEATURE A 6-SPEED AUTOMATIC GEARBOX WITH TWO WET RUNNING CLUTCHES (DUAL CLUTCH) IN WHICH THE CLUTCH MECHANISM AND GEAR CHANGES ARE ELECTROHYDRAULICALLY OPERATED BY A MECHATRONIC CONTROL UNIT.THE DSG MECHATRONIC CONTROLLER INCLUDES EXTENSIVE SELF DIAGNOSTIC FUNCTIONS AND STRATEGIES TO ENSURE SAFE OPERATION AND PREVENT SYSTEM/COMPONENT DAMAGE IN THE EVENT OF COMPONENT FAILURES OR HARSH OPERATING CONDITIONS.THE BASIC HIERARCHY OF FAULT MODES INCLUDES SOME THAT ONLY RESULT IN THE STORAGE OF A DIAGNOSTIC TROUBLE CODE (DTC) AND CAUSE NO LOSS OF FUNCTION, SOME THAT STORE A DTC AND REDUCE VEHICLE OPERATION TO A LIMP HOME MODE, AND SOME THAT STORE A DTC AND CAUSE AN INTERRUPTION OF MOTIVE POWER (I.E., OPEN CLUTCH).THE DRIVER IS ALERTED TO THE LATTER TWO MODES BY THE DASH GEAR POSITION INDICATOR (PRNDS) FLASHING. ONE OF THE CONDITIONS THAT RESULTS IN INTERRUPTION OF MOTIVE POWER IS EXCESS GEARBOX TEMPERATURE.THE SYSTEM INITIALLY RESPONDS TO INCREASED GEARBOX TEMPERATURE BY RAMPING DOWN ENGINE TORQUE.IF THE TEMPERATURE KEEPS RISING THE MECHATRONIC UNIT RESPONDS BY OPENING THE CLUTCH.IN A DEFECT INFORMATION REPORT SUBMITTED TO NHTSA ON AUGUST 20, 2009, VOLKSWAGEN DESCRIBED A POTENTIAL DEFECT IN THE WIRING HARNESSES OF THE DSG GEARBOX TEMPERATURE SENSORS USED IN APPROXIMATELY 16,000 MODEL YEAR (MY) 2009 AND 2010 VOLKSWAGEN (EOS, JETTA AND GTI) AND AUDI (A3 AND TT/TT ROADSTER) VEHICLES EQUIPPED WITH DSG …